top of page

- Design Guideline -

we have provided the following information and guidelines to help you get the most out of your design.

Prepare your artwork

Get your sticker design in JPG, PNG, PDF, AI format with the guide line below :

1. Add 1.5mm of bleed 

When prepre your artwork, Give the extra 1mm for the cutting bleed. For example, if your final sticker size is 50mm x 50mm, the design you send over should be 52mm x 52mm. (refer to picture above). The content( text or sensitive information) must be contained in the red box, (this is actual sticker size) , we will cut off the area outside of red box.

2. Keep your content within a 3mm safety margin

During the production of sticker, slight cutting imperfections are to be expected - cutting can be off by a couple of millimeters from the cutting line. To allow leeway for such imperfections, Make sure all colors, background pictures, and elements extend to the edge of the bleed area, to avoid the appearance of white borders on certain edges after cutting.

3. Use CMYK colour profile

You artwork should be prepared in CMYK colour mode. Keep in mind that if the setup is wrong, colours on the finished product may differ from the file you sent.

4. Use an image resolution of at lease 300 DPI

To avoid blurriness, use only images and graphics that have a resolution of 300 DPI or more at actual size.

bottom of page